3/31/2024 0 Comments Asme y14.5 standard![]() ![]() I'm a vegetarian because I HATE plants!! RE: Hole Notes (ASME Y14.5M-1994) ctopher (Mechanical) 21 Feb 12 12:41 I'm not a vegetarian because I dislike meat. 22 depth hole be the proper diameter to allow the end of a threaded fastener to pass through? Or will it be a pilot hole drilled for a #2-56 thread? I would obviously want to communicate that the drill diameter is whatever is appropriate for the helicoil insert. Is that correct? Will the drill used for the. How would one go about making a hole note for a helicoil insert while simultaneously communicating the parameters below: ![]() Lastly, we use a lot of helicoils on our parts. and if I want the hole fully threaded? Is that even possible? What about the drill tip? Is that part of the depth stated on the drawing? Or does it always go beyond the stated depth value by some amount? 18 depth dimension the tap is? If not, what is the proper way to control the depth of the drill? I would assume the following: but what does that mean in regards to the drilling operation done before tapping? Is the drill tip going to be held to the same. 18, I would think that the hole note should look like the following: If I've got a tapped hole (#2-56 UNC 2B) with a depth of. I have an idea of how it should be, but I'm unsure. So we've had a question about our notes for some time where I work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |